Banner American Easy-LAM II Specifications download pdf (Page 14)

3. Turn the knob clockwise to increase and counterclockwise to

decrease the temperature. If reducing the temperature, wait several

minutes for the heat to drop to the desired operating temperature.

When increasing temperature, the indicator lamp will come on as the

laminator is heating up and go off when it reaches the set temperature.

(Wait 10 minutes between each adjustment before using the laminator.

This will let the heat stabilize).

4. Check the thermometer to see if the desired temperature has been

reached. You may have to make a few minor adjustments before

optimum temperature is set. Most laminating film laminates within a

given temperature range so an exact temperature reading is not

necessary.

Laminating

1. When the motor is first turned on, allow 6” of film to clear heat

shoes for best laminating results.

2. Be sure the heaters have been turned on and are at the proper

temperature.

CAUTION! Do not allow the temperature to exceed 350°F as this

could cause the laminating film to melt on the heat shoes.

3. Adjust the paper guide on the feed table so that the right edge of

the item will enter the laminator at the desired position.

4. Press the motor switch to the “on” position. The film will begin

moving through the laminator.

5. When you begin laminating after the film has been sitting on the

heat shoes for a while, you should let about 6” of the film run through

the machine before you insert an item to be laminated.

6. After clear laminating film exits the pull rollers at the rear of the

machine, you may slide the first item to be laminated into the

laminator with the right edge along the paper guide.

abcoffice

www.abcoffice.com

1-800-658-8788

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

No comments

Banner American Easy-LAM II Specifications Page 14