Banner American Easy-LAM II Operations Instructions download pdf (Page 5)

 Unplug the laminator before moving it or when it is not in use for

an extended period of time as a precaution against the possibility

of an internal malfunction that could create a fire hazard.

 Do not operate the laminator with a damaged power supply cord

or plug, or after it malfunctions or has been damaged in any

manner.

 Keep the power cord away from hot or wet surfaces.

 Do not overload electrical outlets beyond their capacity as this

can result in fire or electrical shock. This unit is rated at 15 amps

(12 amps CSA) and should be the only item plugged into a 15 or

12 amp branch circuit. When connected to a 20 amp branch

circuit any items in addition to the EZ27 must not exceed 4 amps.

 Adjust only those controls that are specified in these Operating

Instructions.

 Do not attempt to service or repair the laminator yourself. Unplug

the laminator from the electrical outlet and contact an authorized

service representative under any of the following conditions:

• When the power supply cord or plug is damaged or frayed.

• If liquid has been spilled into the laminator or it has been

exposed to water.

• If the laminator has been subjected to excessive jarring

through being dropped or bumped.

• If the laminator does not operate normally when following the

operating instructions.

INTRODUCTION

Congratulations on your purchase of the EZ27 Roll Laminator. This unit is

designed to provide years of trouble-free service.

The EZ27 will accept rolls of laminating film up to 27” wide in both 1.5 and 3 mil

thicknesses. Paper and card stock up to 80mm thick may be laminated without

adjusting the feed rollers. Individual temperature controls and indicators provide

uniform temperature on both sides of the item being laminated.

2 15

1 2 3 4 5 6 7 8 9 10 11

No comments

Banner American Easy-LAM II Operations Instructions Page 5