Banner American Easy-LAM II Specifications

EZLam School Budget Roll Laminator READ BEFORE OPERATING MACHINE FAILURE TO LOAD FILM CORRECTLY WILL VOID ALL WARRANTIES

10 4. Repeat for Bottom Supply Mandrel. 5. If you are not ready to laminate, turn the Motor switch off and Heat Switches off. Setting Roller Tem

11 7. Use the Zippy Cutter to cut across the film to remove the laminated items from the unit. TROUBLESHOOTING The following guide will assist

12 PROBLEM: Blistering of the film appears over the item or along the edge. ACTION: Reduce roller temperature. Clean laminating rollers.

13 4. Lift the film away from the rollers. Turn the power on and hold the Motor Drive switch in the REV position while pulling the film forward tow

14 WARRANTY AND RETURN POLICY Warranty Your laminator is warranted to be free of defects in material and workmanship for a period of 1 year from the

2 TABLE OF CONTENTS Safety Messages and Electrical Safeguards……………..3-4 Introduction ...

3 IMPORTANT SAFETY MESSAGES AND ELECTRICAL SAFEGUARDS For your protection, do not connect the laminator to electrical power or attempt to operate

4  Do not overload electrical outlets beyond their capacity as this can result in fire or electrical shock. This unit is rated at 15 amps and shou

5 INTRODUCTION Congratulations on your purchase of the new EZLam School Budget (EZSB) Roll Laminator. This unit is designed to provide years of

6 INITIAL SETUP Unpacking and assembly... Before unpacking the unit, inspect the shipping container for signs of damage. Notify the carrier and yo

7 Motor Master Switch: Cuts power to FWD/REV Switch. Allen Key: Use to adjust film tension. Heat Control Your new EZSB has a digital heat controll

8 Figure 3 2. Pull 6"-12" of film from the top roll. Pass the film under the idler bar and over the roller. Make sure the shi

9 Figure 5 5. Turn the Motor switch to FWD to start the Laminating and Pull Rollers.