Banner American Easy-LAM II Specifications download pdf (Page 10)

4. Repeat for Bottom Supply Mandrel.

5. If you are not ready to laminate, turn the Motor switch off and Heat Switches off.

Setting Roller Temperature...

The laminator temperature should be adjusted according to the film thickness and the item being

laminated. See Table 1 on the next page for recommended temperature settings. Keep in mind

that the temperatures listed are approximate and different brands of laminating film may require

different temperatures.

1. Turn the Heater switch on.

2. Adjust using digital heat controller. To set the temperature press and hold the appropriate

arrow until the desired temperature is reached. Then press both arrows to save the setting.

Material Temperature Range

1.5 mil (.0015”) 270°F – 280°F

3 mil (.003”) 245°F - 255°F

Table

LAMINATING

1. Be sure the heaters have been turned on and are at the proper temperature. Be sure the film

has been properly threaded.

Caution:

Do not allow the temperature to exceed 300°F as this could cause the silicone

coating to separate from the roller core on the heated rollers and will void your

warranty.

2. Adjust the Paper Guide on the Feed Table so that the right edge of the item will enter the

laminator at the desired position.

3. Press the Motor switch to the ON position. The film will begin moving through the laminator.

4. After clear laminating film exits the Pull Rollers at the rear of the machine you may slide the

first item to be laminated into the laminator with the right edge along the Paper Guide.

Note: You may want to run a test lamination first as any item that passes

between the rollers will be laminated and cannot be recovered until it exits

the rear of the laminator.

5. Additional items may be fed in sequence, keeping enough distance between sheets for

trimming.

6. After the last item has exited the Pull Rollers, turn the Motor switch off.

1 2 ... 5 6 7 8 9 10 11 12 13 14

No comments

Banner American Easy-LAM II Specifications Page 10